Inspect the toilet to ensure no damages have occurred during transit .
BEFORE INSTALLATION:
Confirm that the item received will fit in the intended location and that
plumbing fixtures are located where legally required before installation
begins.
Failure to follow the relevant installation instructions will void the
warranty.
Installation should be done by a licensed professional. Installation should
conform to local codes.
INSTALLATION INSTRUCTIONS
APPLICABLE MODELS:
PL-12210
TOILET
PL-12228
Install closet bolts in flange channel, turn
90 degrees, and slide into place 6" (152
mm) apart and parallel to wall.
STEP 1: INSTALL CLOSET BOLTS
Invert toilet on floor (cushion to prevent
damage), and install wax ring evenly
around waste flange (horn), with tapered
end of ring facing toilet. Apply a thin
bead of sealant around toilet base.
STEP 2: INSTALL WAX SEAL
STEP 3: POSITION TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet
flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked ‘THIS SIDE UP’ must face up!
STEP 4: INSTALL TOILET
a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax
ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED!
b. Adhere bolt covers to toilet
c. Smooth off the bead of sealant around base. Remove excess sealant.