STAINLESS STEEL UNDERMOUNT SINKS
INSTALLATION INSTRUCTIONS
www.buildpelican.com
Read instructions carefully before installation. Inspect sink for any damages. Do not install
damaged sink as this will void the warranty.
Pelican Int’l recommends that installation be done by a licensed professional installer.
BEFORE INSTALLATION:
Pelican undermount sinks should only be fastened to a solid surface countertop (i.e. quartz,
granite, etc).
Pelican recommends that sink cut out and mounting holes be cut by the countertop
fabricator prior to installation.
Follow all local plumbing and building codes.
Pelican is not responsible for improper sink or countertop installation. Pelican is not liable for
any damages to sink, countertops, or personal injury during installation.
If you purchased a handmade sink, a template was provided. For all other undermount
stainless steel sinks, a template is available upon request. Installers can retrieve desired DXF
files for all undermount stainless steel sinks from our website: www.buildpelican.com
INSTALLATION PROFILES:
Alignment of sink to cut out is vital for a proper fit and finished look. Based upon your own
aesthetic preference, Pelican undermount stainless steel sinks can be installed flush mount,
reveal, or overhang.
FLUSH MOUNT
REVEAL
OVERHANG
Countertop meets the
edge of the sink, creating a
flush fit with the sink bowl.
Countertop edge sits slightly back
from the edge of the sink and
exposes sink rim.
Countertop extends slightly
over the edge of sink on all
sides.
INSTALLATION INSTRUCTIONS
STAINLESS STEEL UNDERMOUNT SINKS
Fasten mounting brackets loosely into the pre-drilled mounting holes in the countertop.
Apply good quality silicone caulk evenly around the top of the sink flanges.
Position and align the sink under the countertop opening. Press the silicone and flange up
onto the countertop.
STEP 1:
STEP 2:
STEP 3:
From the underside, gently tighten the fasteners with a screw driver until the sink is snug
against the countertop.
Check alignment of the sink in the countertop opening and then tighten fastners until the sink
is tight against the countertop. Do not overtighten.
Wipe away excess silicone caulk with rag.
INSTALLATION INSTRUCTIONS
STAINLESS STEEL UNDERMOUNT SINKS
Clean underside of countertop and rim of the sink.
Check alignment of sink to countertop opening and move slightly if needed.
COUNTERTOP
ANCHOR
SILICONE
CAULK
SINK
MOUNTING
CLIP
SCREW
FLUSH MOUNT INSTALLATION EXAMPLE