Stainless Steel Top Mount Sinks

Welcome to interactive presentation, created with Publuu. Enjoy the reading!

STAINLESS STEEL TOP MOUNT SINKS

INSTALLATION INSTRUCTIONS

www.buildpelican.com

Read instructions carefully before installation. Inspect sink for any damages. Do not install

damaged sink as this will void the warranty.

Pelican Int’l recommends that installation be done by a licensed professional installer.

BEFORE INSTALLATION:

Pelican recommends that sink cut-out and mounting holes be cut by the countertop

fabricator prior to installation.

Follow all local plumbing and building codes.

Pelican is not responsible for improper sink or countertop installation. Pelican is not liable for

any damages to sink, countertops, or personal injury during installation.

It is recommended installers use the actual sink for tracing cut-out if cut-out not already

done. Installers can also retrieve desired DXF files for all top mount stainless steel sinks from

our website: www.buildpelican.com.

Apply silicone caulk around the cutout in the countertop surface.

Carefully lower sink into the cutout.

Assemble the clips and screws.

The number and placement of mounting clips should be determined based on the overall

size of the sink rather than a fixed distance between clips. In general, clips should be

evenly spaced along both the length and width of the sink to ensure the basin remains

level and securely mounted. For example, a 23" x 18" sink typically requires two clips on

each long side and two on each short side, evenly distributed to keep the sink level. The

same number of clips may also be used for larger sinks, such as 32" x 18", but the spacing

between clips will naturally be wider due to the larger size.

From the top, check the seal between the sink edge and countertop. Lightly tighten clips

evenly with a screwdriver until the sink is tight to the countertop. Do not overtighten.

Wipe away excess silicone caulk.

INSTALLATION:

COUNTERTOP

SINK

INSTALLATION INSTRUCTIONS

STAINLESS STEEL TOP MOUNT SINKS

Always ensure that clips are installed in positions that evenly divide each side, providing

balanced support around the perimeter of the sink.

1 2

Made with Publuu - flipbook maker