Granite Composite Sink Care and Maintenance Guide

Welcome to interactive presentation, created with Publuu. Enjoy the reading!

6140 Ulmerton Rd. Clearwater, FL 33760

Phone: (727) 388-9895

Fax: (727) 362-1281

www.buildpelican.com

Deep Clean: Pour approx. two centimeters of hot water (approx. 140°F) into the

sink. Add one dishwasher tab or 2 tablespoons of a standard household

dishwashing detergent to the hot water and stir well until the tab is clearly

dissolved (caution: risk of scalding). You can apply a generous amount of the

cleaning solution to the draining board or the edge of the sink using a dishwashing

brush. Allow the lye to run off after 90 minutes and rinse the entire surface with

plenty of cold water. If necessary, use the damp eraser sponge to remove any

remaining residue. Then rinse well again, wipe the sink with a dry, soft cloth and

leave to dry for at least 30 minutes.

CLEANING INSTRUCTIONS

Dark Granite Composite Sinks

Onyx | Gunmetal | Mocha | Concrete

TO DEEP CLEAN YOUR DARK CRYSTALLITE SERIES SINK, PLEASE PROCEED AS FOLLOWS:

Degrease: Pour plenty of water and a little washing liquid onto a soft dishwashing

sponge (without a scrubbing pad) or an eraser sponge and wipe over the sink in a

circular motion. Rinse with plenty of clean water and then dry the sink with a soft

microfiber cloth.

Descale: To remove stubborn limescale deposits, soap residue or gray haze,

apply any mild descaler evenly to the affected surface and leave to work for 15

minutes. Then rinse with clean water and wipe dry. Repeat for stubborn

limescale deposits.

Sealing: The sink must be completely clean and dry before sealing. Cover the parts

not to be treated with a film and apply a sealant (approved for kitchen and

bathroom sinks) as thinly and evenly as possible. It is best to apply a small amount

of sealant to the surfaces to be treated and spread carefully with a clean fleece or

microfiber cloth. After 1 minute, remove any excess sealant with a dry fleece or

microfiber cloth. The product must be completely absorbed, it must not come to a

standstill on the surface. The freshly treated sink should be protected from

moisture for at least 6 hours, after which it is ready for use again.

Please do not use any highly abrasive cleaning agents such as scouring agents, chlorine-

based cleaners, drain cleaners or alkaline solutions and other solvents - these can cause

lasting damage to your sink. You can easily keep your Pelican sink hygienically clean and

remove even stubborn stains with mild cleaning and care products.

Made with Publuu - flipbook maker